CORELDRAW LASERDRW PLUGIN CRACKED
CORELDRAW LASERDRW PLUGIN SOFTWARE

Amazon doesn’t permit sending video directly, so if you need to show us the video, please contact us through e-mail, our address is in the attachment. If still can’t work, is better take a video or some photos, to show us your operation steps, should include the whole scene, not partial.

CORELDRAW LASERDRW PLUGIN SOFTWARE

Check whether the laser head has returned to the origin after the machine is turned on?Īlso, check those basic installations: machine installation, software installation, connection between PC and machine, whether the switch is turned on, etc. LIMIT SWITCH: is the lid closed while working? Our newest machine no longer installs it. This is a very sensitive component, even though the water is just fine. *The valve may be closed, so the water cut protection function is turned on, causing the laser to be interrupted. If you need operating video, we can send you through e-mail. Please cut the wiring of the water shutoff protection valve and connect it directly with the machine's wire to form a closed circuit. Please clean this component, it may be blocked by impurities in the water.

Please open the lid on the back of the machine, the black and white component that is connected to the water pipe is the water shut off protection valve (as shown the photo). Check the WATER SHOUTOFF PROTECTION VALVE: If no light, is the problem of the laser power supply.Ģ. Please prese button on your machine, meanwhile, observe if there has light inside the tube. Please check if there is any problem of the tube itself, especially the wiring at both ends. Please check whether there is water in the two layers inside the laser tube to ensure that the water circulation works well. Also check that the focal length of the focus lens has changed and readjust the focal length. Test each reflective lens with double-sided tape and paper to ensure that the laser path is correct. Are the focusing and mirrors dirty or damaged? (If dirty, it is recommended to wipe or replace the lenses.) Abnormal reflective lens sets can also cause the laser to not come out. (In this case, please email us a photo of the damaged part of the laser tube.) We will provide new replacement laser tubes for after-sales service.

CORELDRAW LASERDRW PLUGIN CRACKED

(Laser power supply may be damaged)ģ, if the lens inside the laser tube is clean, or the laser tube is cracked or damaged, the laser tube needs to be replaced. Press the power test button and place a piece of paper at the outlet of the laser tube to check for burn marks. (Make sure the water cycle is clean, otherwise the protective device on the device will activate and limit the emission of the laser tube.) ）Ģ. HPGL Vinyl cutters known to Work with inkCut Version 2.0.1, whether the cooling water is sufficient, water quality, temperature, water circulation is normal. Silhouette Curio (partial success confirmed in #36) Vinyl cutters known to Work with inkscape-silhouette plugin Version 1.19-1: The controller board is the circuit board the USB cable plugs into' You can also look at the markings on the controller board.

Moshi boards will not work To see which board you have you can go to 'Properties' from the LaserDRW (or CorelDraw) Engraving Manager window and look at which board is selected for the 'Mainboard' option. 'Only boards that work with LaserDRW will work with K40 Whisperer. Note: this list will be updated as users report any issuesīoards known to Work with K40 Whisperer Version 0.24:

Lists known hardware tools and software used to make them work

Coreldraw laserdrw plugin